鏈板輸送帶如何拆卸

鏈板輸送帶兩側大部分采用熱熔封邊處理，因為有更換維修的需要，鏈板輸送帶每3米或5米會留有供維修使用的活接頭，活接頭位置為開口銷封邊。當鏈板輸送帶需要拆卸維修時需要講活接頭位置運轉至輸送機的進出料端鏈輪上方位置，根據現場情況在開銷另一端留出大于鏈板輸送帶的寬度以方便抽出穿桿，安裝時相同。如果有不明白之處可以在施工時聯系鏈板輸送帶生產廠家，隨時溝通。The two sides of the chain conveyor belt are mostly treated with hot melt edge sealing. Due to the need for replacement and maintenance, there are movable joints left for maintenance every 3 or 5 meters of the chain conveyor belt, and the positions of the movable joints are sealed with split pins. When the chain plate conveyor belt needs to be disassembled and repaired, it is necessary to move the movable joint position to the upper position of the sprocket at the inlet and outlet ends of the conveyor. According to the on-site situation, a width greater than the chain plate conveyor belt should be left at the other end of the overhead to facilitate the extraction and threading of the rod. The installation is the same. If there are any unclear points, you can contact the chain conveyor belt manufacturer during construction and communicate at any time.